Efficiency in general describes the extent to which time, effort or cost is well used for the intended task or purpose. It is often used with the specific purpose of relaying the capability of a specific application of effort to produce a specific outcome effectively with a minimum amount or quantity of waste, expense, or unnecessary effort. „Efficiency“ has widely varying meanings in different disciplines.

The term „efficient“ is very much confused and misused with the term „effective“. In general, efficiency is a measurable concept, quantitatively determined by the ratio of output to input. „Effectiveness„, is a relatively vague, non-quantitative concept, mainly concerned with achieving objectives. In several of these cases, efficiency can be expressed as a result as percentage of what ideally could be expected, hence with 100% as ideal case. This does not always apply, not even in all cases where efficiency can be assigned a numerical value, e.g. not for specific impulse.

A simple way of distinguishing between efficiency and effectiveness is the saying, „Efficiency is doing things right, while Effectiveness is doing the right things.“ This is based on the premise that selection of objectives of a process are just as important as the quality of that process.

A slightly broader mode of efficiency that nevertheless remains consistent with the „percentage“ definition in many cases is to say that efficiency corresponds to the ratio r=P/C of the amount P of some valuable resource produced, per amount C of valuable resources consumed. This may correspond to a percentage if products and consumables are quantified in compatible units, and if consumables are transformed into products via a conservative process. For example, in the analysis of the energy conversion efficiency of heat engines inthermodynamics, the product P may be the amount of useful work output, while the consumable C is the amount of high-temperature heat input. Due to the conservation of energyPcan never be greater than C, and so the efficiency r is never greater than 100% (and in fact must be even less at finite temperatures).

source Wikipedia

Categories:

Tags: